Unpacking The Appliance; Installation Instruction - TESY CH 1760 1T IX Instructions For Use And Maintanence

UNPACKING THE APPLIANCE

•
Upon unpacking the appliance please verify that it has
not been damaged during transportation and it has been
delivered in full! In case of any damage or incomplete
delivery, please contact your authorized seller!
•
Do not dispose of the original box! It may be used
for storage and transportation to avoid any possible
damages resulting from transportation!
•
Disposing of the packaging material shall be done
in the suitable manner!
•
Children shall not play with the polyethylene bags!
CONTENTS OF THE PACKING BOX
The contents of the packaging may vary depending on
the specific model:
CH 1760 1T IX
•
Range hood CH 1760 1T IX
•
Aluminium filter kit
•
Upper and lower chimney body
•
Mounting bracket for fixing the range hood
•
Mounting brackets for fixing the chimney bodies
•
Non-return flap
•
Flexible tube
•
Adapter Ø150 mm - Ø120 mm
•
Installation kit
•
Instruction manual
•
Warranty card
•
Energy label
•
Product fiche
CHOOSING A LOCATION FOR INSTALLATION OF
THE RANGE HOOD
When installing the range hood, You must observe
at least 65 cm distance from the range hood and the
surface on which cookware will be placed.
Figure 1 – Requirement for minimum distance from the
working surface
English
RISK OF POISONING AND DEATH!
There is risk of poisoning by inhaling the exhaust
gases. Do not use the appliance simultaneously with
appliances which generate poisonous gases that are
released through a chimney, like for example stoves
running on gas, coal, fuel oil or wood, unless proper
ventilation has been provided. Such type of heating
appliances use air for burning at the place of their
installation and release the exhaust gases through the
chimney. The air gets sucked out from the kitchen or
the adjacent room when the range hood operates. This
generates vacuum unless fresh air flow is provided. In
this case the exhaust gases are sucked in back from the
exhaust pipes and fed back into the room. Therefore,
proper ventilation of the room must be provided.
RISK OF FIRE!
Installation of the range hood over an appliance
which runs on solid fuel (wood or coal) is allowed only
in case the appliance is permanently assembled. The
local regulations regarding the mains electricity shall be
observed.
If the appliance has not been cleaned in accordance with
the cleaning instructions it is possible to suck in sparkles
or other small burning particles and thus to cause fire.

INSTALLATION INSTRUCTION

The CH–series chimney-type range hoods are designed
for wall-mounting. Figure 3 below shows the distances
for the installation holes.
Instructions for use and maintenance
EN
5