Unpacking The Appliance - TESY FS4001M50 WH Instructions For Use And Maintenance Manual

Table of Contents

Advertisement

Available languages

Available languages

Any installation done by unauthorized personnel
may result in lower performance, damage to the
appliance or accidents.
Do not plug the appliance in the socket before the
electrical connections have been completed.
The socket shall be accessible at all times so that the
plug can be taken out of it immediately if necessary!
Never pull the power cord or the appliance itself
while unplugging it from the mains.
Should you decide to stop using an appliance of
this kind, it is recommended to render it unusable
by cutting off its cord after you have disconnected
it from the mains. It is also recommended to secure
all appliance-related risks, especially with regards to
children who may use the appliance to play with it.
Do not touch the lamps if they have been on for a
long time – they may burn your hands because they
are hot.
Follow the relevant rules and guidelines for ducting
out the exhaust air.
You need to provide adequate ventilation in a room
where the range hood will be used simultaneously
with an appliance which burns gas or another type
of fuel (Not valid for appliances which recycle air
back into the room).
There is a risk of fire if the cleaning is not done in
accordance with the instructions.
Clean the appliance regularly. You must disconnect
it from the mains prior to cleaning it.
Never touch the appliance with wet or damp hands
– this is dangerous for your life!
You shall not light any food on fire (flambé) under
the range hood.
The exhaust air shall not be discharged in a chimney
which is used for discharging the exhaust gases
from appliances using gas or other type of fuel (Not
valid for appliances which recycle air back into the
room).
During installation you should observe the
minimum distance between the hot plate surface
on which cookware will be placed. When the range
hood is placed over domestic appliance which
uses gas, then the distance shall be at least 65 cm.
If the instruction manual of the gas hot plate itself
indicates bigger distance, then it should be taken
into account. The distance of 65 cm may be reduced
for the inflammable parts of the range hood and for
parts which operate under safe ultra-low voltage,
which, if they get deformed, will not give access to
parts that are charged with voltage.
Switch on the range hood only after You have
placed a frying pan, cooking pot or another
cookware on the hot plate. Otherwise the heat may
cause deformities to some parts of the range hood.
English
Do not leave cookware with hot oil on the hot plate.
Cookware containing hot oil may cause self-ignition.
Be careful with curtains and table cloths while
cooking, e.g. frying, because the oil may set them
on fire.
Ensure that filters are replaced in time. Filters that
are not replaced/cleaned pose risk of fire due to the
greasy deposits on them.
Do not use materials which are not heat resistant
instead of filters.
Do not use the range hood without the aluminium
filters. Do not remove the filters while the appliance
is operating.
In case of fire disconnect the power supply of the
range hood and of the stove. (Unplug the appliance
from the power socket or switch off the circuit
breaker.)
Switch off the appliance during its maintenance.
(Unplug the appliance from the power socket or
switch off the circuit breaker.)
If the range hood and another appliance running
on energy different from electricity operate
simultaneously, the negative pressure in the room
shall not exceed 4Pa.
If in the same place where the range hood is located
there is also an appliance on liquid or gaseous fuel,
then this appliance shall be placed in an airtight
container.
If you are discharging the exhaust air through the
chimney, use pipes with diameter 120 or 150 mm.
The pipe connection should be as short as possible
and to have the minimum possible number of
curves.
Use a circuit breaker with maximum current of 6
Ampere at the installation of the range hood for
your safety.
If the cord is damaged, it has to be replaced by an
authorized service centre or qualified technician in
order to avoid any dangerous situations.
In case of fire disconnect the power supply of the
appliances, extinguish the fire; never use water!

UNPACKING THE APPLIANCE

Upon unpacking the appliance please verify that it
has not been damaged during transportation and it
has been delivered in full! In case of any damage or
incomplete delivery, please contact your authorized
seller!
Do not dispose of the original box! It may be used
for storage and transportation to avoid any possible
damages resulting from transportation!
Disposing of the packaging material shall be done
in the suitable manner!
Children shall not play with the polyethylene bags!
Instructions for use and maintenance
EN
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fs4001m60whFs4022m60whFs4032m60ixFs4042m60wh

Table of Contents