Connections To Radio Module; Exceptional Case - Vehicles With Factory Dsp Amplifier - Caraudio-Systems C2-MK-CD Manual

C.logic interface for bmw professional navigation systems without idrive

Table of Contents

3.3.

Connections to radio module

Picture exemplary for vehicles with Quadlock connector at factory radio module.

3.3.1. Exceptional case – Vehicles with factory DSP amplifier

If the vehicle is with factory DSP amplifier, it is possible, that the CD-changer sound is not

connected to the analogue input of the radio module, but to the digital input (44.1khz) of

the factory DSP amplifier. In this case an analogue-digital converter or a digital output

(44.1khz) of the source(s) is required and this part of the manual (connection at the radio

module) can be skipped.

If the factory CD-changer is installed, it is possible to check prior to installation of the

interface whether it is connected to the factory DSP amplifier with a digital coax cable. If no

factory CD-changer is installed, it is possible to check whether the factory DSP amplifier has a

digital connector (SMB). If so, it is only possible to check whether the system is coded to

analogue or digital by try-and-error.

Version 10.05.2012

C2-MK-CD

Table of Contents

Do you have a question about the C2-MK-CD and is the answer not in the manual?