Supra Dalbeo Presence 1022 Installation And Operating Instructions Manual page 24

3 important steps are needed for the first use of the pin code lock:
1- PIN code initialisation, enter the preset PIN code (0000) to access to the feature.
2- Activation of the PIN Code to lock settings which will be protected by the PIN code.
3- Customizing the PIN code, replace 0000 by the custmized code.
PIN code initialisation
By default, the PIN code is not enabled. The setting access is available in Standby mode only.
Select the Standby mode by
1
pressing Standby.
The PIN code is initialized, the next setting automaticaly appears: PIN Code activation.
Activation/deactivation of the PIN Code
1
appears on the display.
Press Minus or Plus to enable PIN code.
appears on the display.
= PIN code enabled.
= PIN code disabled.
The PIN code is enabled. Any modification of reserved settings listed
beep
20 sec.
Simultaneously press the
2
Mode and Plus for at least 20
seconds.
2
By default registered PIN code
3
is 0000.
Press Minus or Plus to select
0. It is blinking, save and press
Mode to exit.
2
Press Mode to save and return to Standby mode.
in "Overview" is now impossible.
24
1
For others numbers, select 0
4
by press Mode.
When 0000 appears, press on
Mode again to save and exit.
FR9011450-60-70B-0322