At The End Of The Self Clean Program; The Self Clean Program Is Canceled - Miele HR 1136-1 G Operating Instructions Manual

At the end of the Self Clean program

  

,  and  will appear in the dis-
play.
The door is locked as long as the 
symbol is lit up. The  symbol will start
flashing as soon as the door lock has
been deactivated.
When the door lock has been deacti-
vated:
–  goes out,
–  flashes,
– short signals will sound if the signal
tone is activated (see "Settings –
 ").
 Turn the mode selector to Off.
Acoustic and visual signals are turned
off.

Danger of burns!
Danger of burns! Wait until the oven
has cooled down before removing
any residual soiling left in the oven
compartment from the Self Clean
program.
 Wipe any residues (e.g.ash) left be-
hind after the Self Clean program out
of the oven compartment and off of
any accessories. The amount of ash
will vary depending on how dirty the
oven was.

h

Cleaning and care
Most soiling can be easily removed
using a clean, soft sponge and a mild
solution of warm water and liquid dish
soap.
Depending on the degree of soiling
before cleaning, there may be a visible
layer of soiling across the inner glass
pane on the door. This should be re-
moved using the scouring side of a
dish sponge or with a stainless steel
spiral sponge and liquid dish soap.
Please note:
– There is a fiberglas seal around the
oven interior which seals the inside of
the door. Take care not to rub, dam-
age or move the gasket. Do not clean
the door gasket - the door gasket is
essential for a good seal.
– Spilt fruit juices may cause lasting
discoloration to enameled surfaces.
This discoloration is permanent but
will not affect the efficiency of the
enamel. Do not attempt to remove
these marks.

The Self Clean program is canceled

If the Self Clean program is cancelled,
the oven door will remain locked until
the temperature inside the oven drops
to below 535°F (280°C). The  sym-
bol will light up until the temperature
has dropped below this level. The
door can be opened as soon as the 
symbol starts flashing.
The following will cause the Self Clean
program to cancel:
– Turning the mode selector to Off.
67