Table of Contents
Advertisement
At the end of the Self Clean program
When the duration remaining reaches
00:00 h, a message will appear in the
display to tell you that the door is
unlocking.
When the door lock has been
deactivated:
–
Program Finished
display,
– a buzzer will sound if turned on (see
"Settings - Buzzer tones").
Turn the oven off.
Acoustic and visual signals are turned
off.
Burn hazard!
Wait until the oven has cooled down
before removing any residual soiling
left in the oven compartment after
the Self Clean program.
Wipe any residues (e.g., ash) left
behind after the Self Clean program
out of the oven compartment and off
of any accessories. The amount of
ash will vary depending on how dirty
the oven was.
Most soiling can be easily removed
using a clean, soft sponge and a mild
solution of warm water and liquid dish
soap.
Depending on how dirty the oven was
prior to cleaning, there may be a
visible layer of soiling across the inner
glass pane on the door. This should
be removed using the scouring side of
a dish sponge, a glass scraper, or with
a stainless steel scrubbing pad and
liquid dish soap.
appears in the
Cleaning and care
Extend and retract the FlexiClip
telescopic runners several times after
running the Self Clean program.
Please note:
– There is a fiberglas seal around the
oven interior which seals the inside of
the door. Take care not to rub,
damage or move the gasket. Do not
clean the door gasket - the door
gasket is essential for a good seal.
– After the Self Clean program has
finished, the FlexiClip telescopic
runners may appear discolored or
have a lighter color in some places.
This will not affect the functioning of
the runners in any way.
– Spilled fruit juices may cause lasting
discoloration of enameled surfaces.
This discoloration is permanent but
will not affect the properties of the
enamel. Do not attempt to remove
these marks.
83
Advertisement
Table of Contents
