Delaying The Start Of The Self Clean Program; At The End Of The Self Clean Program - Miele H6560BP Operating And Installation Instructions

As soon as "Timer" is pressed, the
buzzer and the flashing indicator will
turn off.
Delaying the start of the Self Clean
program
To delay the start of the Self Clean
program, select
Set the time you would like the
program to start at.
Confirm with OK.
The door will lock automatically. The
start time set will appear in the display.
appears in the display and the
start time set. The start or end time can
be changed up until the program is
ready to start, to do so select
As soon as the start time has been
reached, the oven heating and the
cooling fan will turn on automatically.
The duration remaining will appear in
the display.

At the end of the Self Clean program

When the duration remaining reaches
00:00 h, a message will appear in the
display to tell you that the door is
unlocking.
When the door lock has been
deactivated:
.
–
– a buzzer will sound if turned on (see
Acoustic and visual signals are turned
off.
.
Wait until the oven has cooled down
before removing any residual soiling
left in the oven compartment after
the Self Clean program.
Most soiling can be easily removed
using a clean, soft sponge and a mild
solution of warm water and liquid dish
soap.
Depending on how dirty the oven was
prior to cleaning, there may be a
visible layer of soiling across the inner
glass pane on the door. This should
be removed using the scouring side of
a dish sponge, a glass scraper, or with
a stainless steel scrubbing pad and
liquid dish soap.
Cleaning and care
appears in the
display,
"Settings - Buzzer tones").
Turn the oven off.
Burn hazard!
Wipe any residues (e.g., ash) left
behind after the Self Clean program
out of the oven compartment and off
of any accessories. The amount of
ash will vary depending on how dirty
the oven was.
85