Table of Contents
Advertisement
GBA H 3100 1 E
6
M
AINTENANCE
6.1
M
AINTENANCE AND REPAIR
Maintenance and repairs on the appliance must only be carried out by an author-
ized professional observing applicable safety regulations.
Improperly executed work will put your safety at risk!
Before any cleaning, maintenance or repair work is carried out, the appliance must
be disconnected from the mains and de-energized. To do so, it is not enough to set
the power switch to OFF. Instead, the mains plug must be pulled or the electrical
circuit must be de-energized, respectively. Check that no voltage is present before
opening the appliance, and lock out the circuit to make it safe against re-energizing.
6.2
C
LEANING AND CARE
Never use steam and/or pressure jet cleaning equipment to clean this appliance!
This might damage the appliance to the point where it may
pose a
Allow the unit to cool down before cleaning it.
Stainless steel is particularly susceptible to scratching!
Remove lime, grease and starch residue immediately to avoid the formation of
stains.
When using a cleaning product, observe the instructions for use provided by its
manufacturer.
The drain with ball valve must be cleaned and the plug must be regreased:
during each cleaning,
after prolonged downtime,
in case of sluggishness of the plug.
Manufacturer recommendation:
Echtermann Spezialarmaturen
Hahn- und Armaturenspezialfett Art.-No. 7616/20
BA
Last revised 11-2017
hazard to your life!
Page 14 of 28
Burn hazard!
November 8, 2017
Rev. 1
Advertisement
Table of Contents
