Working With The Hako-Jonas Machine; Switch Electro-Motor On And Off - HAKO Sweepmaster 980 R Instruction Manual

Operation
5.5 Working With the Hako-Jonas Sweepmaster
The driver is requested to carefully
read this operator's manual. All con-
trols are marked with easy-to-under-
stand symbols that ease familiariza-
tion. First driving attempts should be
limited to clear areas until you are
familiar with all controls and their func-
tions.
Please comply with the fol-
lowing safety provisions:
When working with the
master B980 R/RH all sa-
Hako-Jonas 980 E/EH all sa-
fety measures generally ap-
plicable for handling vehi-
cles and fuels have to be
observed. No passenger
transport admitted with the
Sweepmaster B980 R/RH. War-
Hako-Jonas 980 E/EH. War-
ning and instruction labels
attached to the machine
contain important informa-
tion about safe operation
and guarantee your perso-
nal safety. Before commen-
cing work,
36
the operator has to make
sure that the machine and
its accessories are in proper
and safe condition and
comply with the provision
for safety at work. Do not
operate the Hako-Jonas 980
E/EH without protective de-
R/RH
vices.
5.5.1 Switch Electro-Motor ON and
OFF
For safety reasons, the Ha-
Sweep-
master B980 R/RH
ko Jonas 980 E/EH is equip-
ped with a seat contact
switch. Starting the engine
or running engine is possi-
ble only when the driver is
seated. If the seat contact
switch is activated with the
electro-motor running, reset
by turning the key switch
OFF and ON again.
- Switch all levers and switches to
neutral position.
- Actuate parking brake
- Turn key switch to "I"
Sweepmaster B980
Sweep-
Check the drive pedal for
being in neutral position be-
fore switching ON.
If the Hako-Jonas 980 E/EH Sweepmaster B980 R/RH
is not used within the ad-
missible conditions and en-
vironments of use, the pro-
tective functions may
respond and switch off dri-
ving function without prior
warning.
Slow the machine down to
standstill by the service bra-
ke in that case.
Acknowledge protective
function by key switch.
Overheating of the travel
drive assembly or control
module always entails a
cooling phase.
The seat contact switch de-
activated all functions, dri-
ving function included.
Slow the machine down to
standstill by the service bra-
ke in that case.