Angelcare AC25 User Manual page 5

FOUR CORNER TEST
We reccomend you perform this test when setting up your monitor for the first time.
1. Remove the mattress from the cot and place the Movement Sensor Pad at the approx-
imate centre of baby's sleeping area, once the Sensor Pad is placed put the mattress
back in place on top of the sensor pad.
4
2. Switch ON both Nursery & Parent Units – check both units are paired (connected).
3. Immediately pat your hand lightly and continuously on a corner of the mattress to detect
movement.
4. Step away from the cot.
5. The alarm will sound from the Nursery and Parent Unit after 20 seconds. If the Alarm
does not sound, ensure everything is setup correctly and try again; check battery levels
on all units, – the sensitivity setting may require lowering by a single level due to other
vibrations/movements.
6. If the alarm sounds, pat your hand lightly on the same corner of mattress to detect move-
ment again. It may take up to 8 seconds to recognise movement and for alarm to stop.
7. If the alarm continues, even after lightly patting the corner of your mattress twice, adjust
the sensitivity higher and repeat this test.
8. Repeat this process in all 4 corners of your matress to esnure the sensor pad is reaching
the whole surface of the matress.
Visit Angelcarebaby.com and go to the helpcentre to watch videos for
these steps.
IMPORTANT INFORMATION
• Test your monitor before first use.
• Prior to use and on a regular basis (before placing your child in the cot) always check
the Movement Pad is detecting no movements or vibrations in its environment.
• Test your monitor every time you move the Movement Pad to a different place.
• If your cot does not have a solid, flat, firm surface including a spring or slat base,
place a hardboard between the cot base and the Movement Pad, to ensure correct
operation. The hardboard must measure at least 30 x 30 cm and 6 mm thick.
• The Movement Pad functions with standard cot sprung and foam mattresses
and not memory foam (partial or full), hollow frame construction mattresses
and water beds.
4 | USER MANUAL
AC25_BabyMovementMonitor_Manual_Final.indd 4 AC25_BabyMovementMonitor_Manual_Final.indd 4
Correct positioning
for slatted base
2023-07-12 13:47 2023-07-12 13:47