Figure 24: Remove The Bracket From The Fan - Tektronix SPG8000A Service Manual

SPG8000A Master Sync / Clock Reference Generator Service Manual

Figure 24: Remove the bracket from the fan

4. To replace the bracket reverse steps 1 through 3.
To remove and replace the Option SDI Output boards.
CAUTION.
These output boards contain sensitive components that are easily
damaged. Be careful not to flex the boards as you remove them. Adhere to proper
handling procedures, shown in the beginning of this section.
1. Remove the SDI output board bracket. (See page 70, To remove and replace
the bracket securing the SDI output boards.)
2. Remove the rear panel. (See page 54, Rear panel.)
3. Remove the output boards by carefully pulling them straight up and away
from the Option SDI board.
4. Place the output boards on a static-safe surface.
5. To replace the output boards, handle them carefully, so that you do not flex
the boards or touch the components on the boards. Install the output boards
into J922 and J917 on the Option SDI board.
6. After replacement, secure the output boards to the SDI board with the bracket
attached to the chassis fan.
Maintenance
71