Installing The Fronius String Control 100/12; Selecting Dowels And Screws; Selecting A Location - Fronius String Control 100/12 MET Manual

Table of Contents

Available languages

Installing the Fronius String Control 100/12

Selecting dowels

Depending on the surface, different dowels and screws may be required for installing the

and screws

Fronius String Control 100/12. Therefore, these dowels and screws are not part of the

scope of supply for the Fronius String Control 100/12. The system installer is responsible

for selecting the proper dowels and screws.

Selecting a Loca-

When selecting the location, please observe the following criteria:

tion

Install only on a solid and level surface

The ambient temperature may not fall below -25°C nor exceed +60°C.

The Fronius String Control 100/12 may be installed outside in sheltered areas. Avoid

direct contact with moisture.

Protect from direct sunlight and direct exposure to the elements.

Install under the solar modules where possible.

NOTE! To prevent warping of the

Fronius String Control 100/12, the

device should be installed only on

a flat surface.

Table of Contents

Table of Contents

Do you have a question about the String Control 100/12 MET and is the answer not in the manual?