Pre-Installation And Application Warnings - Directed DB3 Installation Manual

Pre-installation and application warnings

This section highlights important information for this specific firmware and will assist in pricing accordingly, as
START HERE
well as bringing awareness to any operational or vehicle limitations.
Compatibilities and Requirements
T-Harness
T-Harness is not compatible.
compatible
Vehicle Takeover
Firmware notes
Warnings about Remote Start!
Š
•To remote start the engine, all doors must be closed.
•Make sure the wipers are turned off before remote starting.
Restarting: Wait at least 2 seconds before restarting the engine or an error message can appear in the vehicle information display.
Š
Š Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic connector.
Š Refer to the Vehicle connections section following the wiring diagram.
Footnotes
[1] Hood pin: The installation of an aftermarket hood pin is only required on vehicles that are not equipped with a factory hood pin or if
not supported in data.
[2] Tach: An optional connection required on some remote starters, which do not support a tach signal in D2D.
[3] Keyless Entry: Optional but required for OEM Remote Keyless Entry to operate when vehicle is remote started.
[4] Autolights: Connect the Autolight OFF wire only if the vehicle is equipped with automatic headlights.
5
403.HONDA56 3.40 2013 Acura RDX (Smart Key)
©2022 VOXX•DEI LLC. All rights reserved.
No takeover feature is available on Push-to-Start vehicles, the engine will stop when a door is opened.
Keys required for 1 Keys required
programming for operation
0