Table of Contents
Advertisement
!
WARNING
Always turn OFF the air supply and bleed the system before disassembling the Filter Assembly as injury could result.
3.
Loosen the two bolts on the top of the Filter Assembly enough to allow the Filter Elements
to move freely.
4.
Note the location and orientation of the old Filter Elements.
5.
Slide out the old Filter Elements.
6.
Slide the replacement Filter Elements into the Filter Assembly, with the same orientation as
noted in Step 4 above.
7.
Hand tighten the two bolts evenly, then torque each bolt to 20 - 30 in-lbs (2.3 - 3.4 Nm).
Improper torque may damage the gasket.
8.
Slowly apply air pressure to the assembly, checking for leaks.
NOTE!
A small amount of air leakage from the bottom fitting is normal.
NOTE!
Filter replacement part numbers can be found in Section 6 of this manual.
This completes the parts replacement procedures.
0-5562
First & Second
Stage
Cartridges
(as marked)
Optional Two-Stage Filter Replacement
SERVICE
Art # A-02942
CUTMASTER 60i
61
Advertisement
Table of Contents
