ESAB A-14032 Operating Manual page 20

One of 7 segments will always be on when unit is on. The gas bottle will be illuminated and flash
during a gas pressure fault. Bottle will flash when pressure is below a minimum threshold. Bottle
will be on continuously when acceptable.
Factory default: One, or two segments and gas bottle will be illuminated depending on the gas
pressure level. The green indicator in the middle indicates the recommended pressure for the
process (Amps, torch type, lead length). Different processes have different optimum pressures.
Yellow indicates above or below optimum pressure and red indicates unacceptable pressure for
good cutting. Each LED represents 5 psi. Two adjacent LEDs will represent a value in between
the two or 2.5 lb. pressure change.
13. Gas Pressure Selector
Rotate the lower knob to set the gas pressure.
14.
Used for selecting one of the three torch options and torch length for each. SLV will be automat-
ically detected.
Factory default: On, SL60 which includes SL60QD™ (Quick Disconnect)
Press and release the lower knob without rotating it to step through selection of torch type.
NOTE!
If you have gone past the desired setting, you will need to continue to step through all the other torch types and lengths
to get back to return to it.
15. Lead Length Indicator
Used for selecting torch lead length for each torch type ranging between 20' and 100' leads.
Factory default: On, 20'
Press and release the lower knob without rotating it to step through selection of torch type
followed by lead length.
Up to 35' Lead (10.7 m)
Above 35' to 50' Lead (15.2 m)
Above 50' to 75' Lead (22.9 m)
Above 75' to 100' Lead (30.5 m)
NOTE!
If you have gone past the desired setting, you will need to continue to step through all the other torch types and lengths
to get back to return to it.
0-5562
Torch Type Indicator
OPERATION
CUTMASTER 60i
33