Table of Contents
Advertisement
NOTE!
Filter replacement part numbers can be found in Section 6 of this manual.
Installing Optional Single - Stage Air Filter
An optional filter kit (7-7507) is recommended for improved filtering with compressed air, to keep
moisture and debris out of the torch.
1.
Attach the Single - Stage Filter Hose to the Inlet Port 1/4" NPT of the system filter.
2.
Attach the Filter Assembly to the filter hose.
3.
Connect the air line to the Filter using the 1/4" NPT. The illustration shows typical fittings as
an example.
NOTE!
For a secure seal, apply thread sealant to the fitting threads, according to manufacturer's instructions.
Do not use Teflon tape as a thread sealer, as small particles of the tape may break off and block the
small air passages in the torch.
NOTE!
Filter replacement part numbers can be found in Section 6 of this manual
0-5562
Optional Single - Stage Filter Installation
INSTALLATION
CUTMASTER 60i
25
Advertisement
Table of Contents
