ESAB A-14032 Operating Manual page 26

CUTMASTER 60i
Torch
Shield Cup
A-00024_AB
Standoff Distance
3. Hold the torch away from your body.
4. Slide the trigger release toward the back
of the torch handle while simultaneous-
ly squeezing the trigger. The pilot arc
will start.
Trigger Release
5. Bring the torch within transfer distance
to the work. The main arc will transfer to
the work, and the pilot arc will shut OFF.
NOTE!
The gas preflow and postflow are a characteristic
of the power supply and not a function of the
torch.
Trigger
Trigger Release
3
40
Standoff Distance
1/8" - 3/8" (3 - 9mm)
Trigger
Art # A-13150
1
2
4
Art # A-03383
OPERATION
6. Cut as usual. Simply release the trigger
assembly to stop cutting.
7. Follow normal recommended cutting
practices as provided in the power
supply operator's manual.
NOTE!
When the shield cup is properly installed, there
is a slight gap between the shield cup and the
torch handle. Gas vents through this gap as part
of normal operation. Do not attempt to force the
shield cup to close this gap. Forcing the shield
cup against the torch head or torch handle can
damage components.
8. For a consistent standoff height from the
workpiece, install the standoff guide by
sliding it onto the torch shield cup. In-
stall the guide with the legs at the sides
of the shield cup body to maintain good
visibility of the cutting arc. During oper-
ation, position the legs of the standoff
guide against the workpiece.
Shield Cup
Standoff Guide
Torch Tip
Workpiece
Shield Cup With Straight Edge
The drag shield cup can be used with a non
conductive straight edge to make straight cuts
by hand.
WARNING
The straight edge must be non - conductive.
Non-Conductive
Straight Edge
Cutting Guide
A-03539
Using Drag Shield Cup With Straight Edge
Art # A-04034
0-5562