Table of Contents
Advertisement
Echoflex Installation Guide
ELED2 Controller
IMPORTANT SAFEGUARDS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
WARNING:
high voltage and should only be installed by a qualified
installer or electrician. Follow all local codes for
installation. Before terminating the AC power wiring verify
that the main breaker is in the off position and follow the
proper lockout/tag out procedures required by NFPA
Standard 70E.
WARNING:
electrical junction box or wireway.
• This product is suitable for use in dry locations where the ambient
temperature is -5°C to 50°C (23°F to 122°F).
• Do not use outdoors.
• Do not mount near gas or electric heaters.
• Equipment should be mounted in locations and at heights where it
is not subject to tampering by unauthorized personnel.
• The use of accessory equipment not recommended by the
manufacturer may cause an unsafe condition.
• Do not use this equipment for other than its intended use.
• Servicing should be performed by qualified service personnel.
• Pollution Degree: 2.
SAVE THESE INSTRUCTIONS
ELED2 Controller
RISK OF ELECTRIC SHOCK! This device utilizes
For indoor use only! Must install to an
Page 2 of 12
Echoflex
Advertisement
Table of Contents
