Table of Contents
Advertisement
D
F
. 12
IG
Models Without a Follower Plate
1. Connect fill hose to Zerk inlet fitting (D) (F
D
F
. 13
IG
2. For higher viscosity fluids, start pump to rotate
stirring paddle during fill to prevent air pockets from
forming in grease.
Start pump by pressing the manual run
button.
3. Fill reservoir with NLGI grease to max
fill line.
NOTE: Vent port, located in rear of reservoir, should not
be used as an overfill port/indicator.
332298M
F
. 14
IG
4. Remove fill hose.
Models with Top Fill
. 13).
IG
E
MOVING PARTS HAZARD
Moving parts can pinch, cut or amputate fingers and
other body parts.
•
Keep clear of moving parts.
•
Do not operate equipment with lid removed.
•
Disconnect power before removing lid.
1. Disconnect the power from the equipment.
NOTE: If battery disconnect is not available, remove the
power cord (F
F
. 15
IG
. 15).
IG
Setup
max fill line
19
Advertisement
Table of Contents
