Advertisement
FOR 1990 AND NEWER
MURRAY
TRACTORS
WITH A 46" DECK
Tape 46" template onto deck adapter. Mark and then
cut out adapter.
Fasten the angle bracket and the mounting bracket to
the mower deck as shown in figure 34. Use two 5/16"
x 3/4" carriage bolts, 5/16" flat washers and 5/16"
lock nuts. The bolt heads go on inside of mower
deck.
Drill two 5/16" diameter holes in the deck adapter that
will align with the holes in the angle bracket and the
mounting bracket. Assemble the deck adapter to both
brackets using two 1/4" x 3/4" hex bolts, 1/4" flat
washers, nylon washers and 1/4" hex lock nuts. See
figure 28.
t \
ANGLE BRACKET
_1_
HEXLOCKNUT
NYLON WASHER
_
MOUNTING
1/4"FLAT
1/4" x 3/4
LOCATE AND
HEX BOLT _
DRILL HOLES
\\\\
N_N
WASHER _
1/4" FLAT WASHER
1/4" x 3/4" HEX BOLT -_"-_
FIGURE28
Assemble end of hose and hose clamp over the round
opening of deck adapter and tighten clamp. GO
DIRECTLY TO THE OPERATION INSTRUCTIONS
WHICH ARE LOCATED ON PAGE 18.
17
Advertisement
