Instructions For Tractors With Dual Front Deck Suspension Brackets - Craftsman 486.24414 Operator's Manual

STEP 4: (SEE FIGURE 4)
, Place a 1/2" washer (EE) and then a short spacer (Y)
onto a 1/2" x 1-1/2" hex bolt (C). Instal! the bolt in the
bottom hole at the front of the R. H. side plate and secure
it with a 1/2" nylock nut (P). Repeat for the L.H. side
plate,
Skip to step 8 on page 8.
STEP 6: (SEE FIGURE 6)
, Fasten the R.H. side plate (bend facing out) to the two
holes indicated in the tractor frame. Use two 3/8" x 1"
hex bolts (F) and 3/8" lock washers (Z). If the bolts
insert loosely into the tractor frame, use two 3/8" nylock
nuts (Q) on the inside of the frame. Repeat for the LH.
side.
1/2" X 1ol/2"
HEX BOLT (C)
SPACER (Y)
1/2" WASHER (EE)
1/2" NYLOCK
NUT (P)
3/8" NYLOCK NUT (Q)
(IF NEEDED)
\
3/8" x 1" \
h \
HEX BOLT (F)
"\ _j
FIGURE 4
FIGURE 6
iNSTRUCTiONS FOR TRACTORS WITH DUAL
FRONT DECK SUSPENSION BRACKETS
STEP 5: (SEE FIGURE 5)
, Remove bolts from holes shown in illustration if they
are present.
REMOVE BOLTS
FROM THESE HOLES
\
FIGURE 5
X\
FRONT
SUSPENSmON
BRACKET
STEP 7: (SEE FIGURE 7)
, Place a 1/2" washer (EE) and then a short spacer (Y)
onto a 1/2" x 1-1/2" hex bolt (C). Install the bolt in the
bottom hole at the front of the R.H. side plate and secure
it with a 1/2" nylock nut (P). Repeat for the LH. side
plate.
Go to step 8 on page 8.
HEX BOLT (C) SPACER (Y)
1/2" NYLOCK
1/2" WASHER
(EE) NUT (P)
FIGURE 7