Table of Contents
Advertisement
To take the system out of Valet Mode
Using the KEY (Ignition Valet Mode):
1.
Insert the ignition key into the ignition switch. Within 10 sec., cycle the ignition key to the
IGNITION/RUN and OFF positions 5 times until the parking lights flash twice.
2.
Turn the ignition OFF.
3.
The LED on the antenna will flash rapidly, indicating that the vehicle is now out of Valet
mode.
Using the TRANSMITTER (Remote Valet Mode):
1.
Press and hold the
and
pauses, then beeps once again. Release the buttons.
2.
The
and
button will flash 3 times.
3.
The LED on the antenna will flash rapidly, indicating that the vehicle is now out of Valet
mode.
If someone has attempted to remote-start the vehicle while in Valet Mode; the parking lights will
turn ON, then OFF, then flash twice.
Panic Mode
Note: Panic mode can only be activated if the horn has been adequately configured by the
installer.
In an emergency situation, you can activate panic mode by pressing and holding the AUX button
until the horn starts honking. If the vehicle is under a remote start, the engine will shutdown
automatically before setting off the horn. You can stop the horn by pressing:
(this will lock your doors and deactivate panic mode), or
(this will unlock your doors and deactivate panic mode).
Furthermore, the panic mode can be stopped by activating Valet Mode (page-9)
* Panic Mode will automatically shut down after 30 sec.
Quick Lockout
TM
(Also called Secure Panic.) For fast protection in emergency situations, the system will LOCK all
doors when you press the brake pedal while you hear the Horn sounding. (Quick Lockout is only
available when Panic mode has been triggered.)
Cold Weather Mode
If the vehicle has a manual transmission, Ready mode (page-7) should be set before entering
Cold Weather Mode. When Cold Weather Mode is active, the engine starts every 2 hours and runs
for 3 minutes or 18 minutes (or for 8 or 20 minutes with diesel engines). Cold Weather Mode
automatically ends after 24 hours (or 12 starts). Programmable by installer.
To enter Cold Weather Mode (2-way remote):
1.
Press and release the AUX button.
2.
The
button on the transmitter will light up.
3.
While the
button is still lit, press and hold the
once, pause, then beeps twice.
4.
Release the
button. Its LED will flash quickly.
P.10
buttons simultaneously until the remote beeps once,
button until the remote beeps
User Guide
Advertisement
Table of Contents
