Table of Contents
Advertisement
6.9 Headrests
Headrests
The headrest (Fig. 6.30) can be raised and moved
horizontally both forwards and backwards.
To do this, loosen the screw (1,2 or 3).
Now you can adjust to the desired position. Tighten
screws again (see the page on torque).
6.10 Options – Hemiplegic armrest
Hemiplegic armrests
The hemiplegic armrest can be adjusted both in length
and angle. You can adjust the length by pushing the
armrest after having loosened the 2 rotary screws (1). To
adjust the angle, open the release lever (2) and rotate the
armrest to the desired position, then tighten it again (Fig.
6.31).
6.11 Sideguards
Desk Sideguard, Flip-Up, Detachable with Short or
Long Armrests, Height-Adjustable (Fig.6.32-6.33)
For a more comfortable seating position, you can adjust
the height of the armrest as follows:-
Adjust the height of the armrest as follows: Slide the knob
(1) forward until it stops. Adjust the armrest (2) to the
desired height. Slide the knob toward the back and push
the armrest (2) down until you can hear it click into place.
Always make sure that the sideguards have locked into
place properly. To flip the armrest up, lift the handle (3) to
unlock the sideguard.(Fig. 6.32)
To fully remove the sideguard, flip the sideguard fully up
(1), then rotate slightly outwards (2) and pull out upwards
(3).(Fig. 6.33)
CAUTION!
Neither the sideguards nor the armrests are to be used
for lifting or carrying the wheelchair.
WARNING!
Always make sure that the armrests are properly locked
after height-adjustments.
WARNING!
Do not use the armrest to push up or for transfers.
Rev. A | English
Fig. 6.30
Fig. 6.31
Fig. 6.32
3
Fig. 6.33
2
29
1
2
3
1
2
1
3
1
2
QS5 X
Advertisement
Table of Contents
