Headrests - Quickie Neon 2 Instructions For Use Manual

Height-adjustable backrest
Fig. 6.6.5
The backrest may be set to various back heights, in 2.5 cm
steps (4 adjustment ranges: 25-30 cm, 30-40 cm,
40-45 cm and 45-47,5cm).
Remove the side pads of the upholstery and if necessary the
1
backrest belt covering the screws.
Release the screw (1) and set the backrest to the desired
height, then tighten the screws again, (Fig.6.6.5).
See the page on torque.
CAUTION!
Please take into account the altered centre of gravity
when setting the angle of the backrest, , tension of the
backrest belts or backrest height. This may lead to an unstable
wheelchair likely to tip and may rquire the use of anti-tip tubes.

6.7 Headrests

Fig. 6.7.1
1
Headrests
2
The headrest (Fig. 6.7.1) can be raised and moved horizontally
both forwards and backwards.
To do this, loosen the screw (1,2 or 3).
Now you can adjust to the desired position. Tighten screws
again (see the page on torque).
3
NEON 2 SA
Rev.1.0
27