Quickie QS5 X Directions For Use Manual page 6

Torque
NOTE: Wherever torque settings are specified, it is strongly recommended that a torque meter (not included), is used to
verify correct torque specification is achieved. If no other information is given, the generic torque for M6 screws is 7 Nm.
DANGER: Some of the screws that are used during manufacture are fitted with threadlock, (blue dot on the thread)
and can be undone and re-tightened up to three times before they must be replaced with new screws and threadlock.
Alternatively, you can put Loctite™ 243 threadlock on the screws and re-fit them.
10 Nm
7 Nm
7 Nm
7 Nm
QS5 X
25 Nm
10 Nm
25 Nm
7 Nm
7 Nm
25 Nm
7 Nm
25 Nm
7 Nm
7 Nm
7 Nm
5 Nm
6
25 Nm
7 Nm
7 Nm 7 Nm
EN
5 Nm
7 Nm
1.5 Nm
English | Rev. A