Table of Contents
Advertisement
6.2 Step Tubes
Step tubes are used by attendants to push a wheelchair
over an obstacle. Simply step on the tube to push a
wheelchair, for example, over a kerb or step, (Fig.6.10).
The step tube is equipped with a hinge, so that it will fold
upwards if it gets caught on i.e. a curbstone and therefore
prevents damage and user injury.
CAUTION!
Sunrise Medical strongly recommends the use of a step
tube on any model where attendant use is the
predominant intended use. Damage to the backposts may
occur if you constantly use the backpost without a step
tube, as a lever to pull back on to tip the wheelchair.
6.3 Footrests
Various footboards are available on the QS5 X. These
can be flipped up to make it easier to transfer to/from the
chair. They are described individually.
Footrest and swing away latch
When fitting the footrests these are fitted in the swung-
away position (Fig. 6.11). Then simply turn them inwards
until the interlock engages (1). To remove the footrests,
use the lever (2) and swing the footrest outwards and lift
off. Check that the footrest is correctly engaged.
The footrest will be limited by the hanger stop (Fig.6.11) in
a 90° position. This ensures that the break will not be
inadvertently released when the hanger is swung out.
WARNING!
The footrests are not designed to be used to lift or
carry the wheelchairs with an occupant.
Hanger play adjustment
In case of play the hanger (Fig. 6.12) can be adjusted in
the field. The hanger pin (1) is tapered and the play can
be reduced when the pin is unscrewed slightly.
Take the hanger off the chair in using the release
mechanism.
Use a screwdriver and turn the pin (1) in the front carefully
to the left. Then test the hanger on the chair. If the hanger
mechanism is not working/catching anymore, please undo
the task slightly.
If the play is still too large and the performance not
accepted, please repeat the task.
Rev. A | English
21
Fig. 6.10
Fig. 6.11
2
1
Fig. 6.12
QS5 X
Advertisement
Table of Contents
