Table of Contents
Advertisement
Lightweight footrest
The footrest angle can be adjusted by loosening the
screws (2). Side protection panels can be fitted to the
footrest using the mounting holes (3). These prevent the
feet slipping off accidentally, (Fig. 6.15). Make sure that
after any adjustment work, all screws are tightened
correctly (see the page on torque).
Width adjustment
To adjust the width of the footrest please open the screw
(2). Then you can slide in and out the tubes in the holder
to adjust the width of the footboard (Fig. 6.15).
Please make sure that the screws are tightened with the
correct torque.
Footboard lock
The footplate locks in automatically when flipped down. To
flip it up the release knob (1) must be pulled. To keep the
unlocked position turn knob 1 when it is pulled (Fig. 6.16).
WARNING!
Always make sure to unlock the system to get full
functionality!.
Elevating legrest - standard
To flip up:
Pull the footrest upwards and adjust to the desired height.
When doing this, the footrest clicks audibly into place (Fig.
6.17).
To lower:
Briefly take the load off the footrest by lifting the lower leg
and then push the release lever.
In this way you can swing the footrest downwards. As soon
as you let go of the lever, the footrest will click back into
place.
WARNING!
• There is a risk of trapping fingers when moving the
footrest up or down.
• Do not put your fingers in the adjusting mechanism
between the frame and the moving parts of the footrest.
• The footrests are not designed to be used to lift or carry
the wheelchairs with an occupant.
• When getting into or out of the chair, never stand on the
footboards.
Amputee Support (Fig. 6.18).
The Amputee Support can be adjusted in every direction
as required.
Rev. A | English
23
Fig. 6.15
3
3
2
2
Fig. 6.16
Fig. 6.17
Fig. 6.18
1
QS5 X
Advertisement
Table of Contents
