Quickie QS5 X Directions For Use Manual page 22

Lower leg lengths
By undoing the clamp screw, 1 (Fig. 6.13), you can adjust
the lower leg length. Loosen the clamp screw, adjust the
tube with the footboard to the desired position.
Tighten clamp screws again (see the page on torque).
Ensure that the plastic push joint is located under the
clamp screw in the correct position.
WARNING!
Always maintain a minimum of 30mm between the lowest
part of the footrest and the floor.
WARNING!
Do not stand on the footplate during transfer. The chair is
likely to tip to the front when standing on the footplate.
Always place your feet securely on the ground for
transferring into or out of the chair.
Platform footplates: angle adjustment
To set the correct angle of the footplates relative to the
ground, open the nuts (1) on the underside of the
footplates and set the desired angle of the footplates.
Tighten the nuts to the specified torque. (Fig. 6.14).
QS5 X
Fig. 6.14
22
Fig. 6.13
1
1
English | Rev. A