Quickie QS5 X Directions For Use Manual page 30

Tool Height Adjustable Armrest
Installation: Slide the arm post into the receiver, located
on the wheelchair frame, until it stops
Height adjustment:
Slide the arm rest post out of the receiver.
Adjust the position of the height adjustment bracket (1) by
removing the screw (2) and moving it to the desired
position. Re-fit the screw and tighten it.
Slide the arm rest post back into the receiver, (Fig.6.34).
Armpad Position:
The armpad position can be adjusted by releasing the
screws (3), then moving the arm pad to the desired
position. Re-tighten the screws, (Fig.6.34).
Adjusting Armrest Receiver
The tightness of the armrest receiver can be adjusted
(tightened /loosened) by means of the 2 screws (1) -
(Fig.6.35).
Sideguard With Clothes Protector (Fig.6.36)
The clothes protector prevents clothes getting dirty from
spray water. You can set the position in relation to the
rear wheel by moving the sideguard.
To do this, remove the fixing screws (1 and 2).
After setting to the desired position, re-tighten the screws
(see the page on torque).
CAUTION!
Neither the sideguards nor the armrests are to be used
for lifting or carrying the wheelchair
QS5 X
Fig. 6.34
3
1
Fig. 6.36
1
30
Fig. 6.35
2
English | Rev. A
1
2