Bellfires VERTICAL BELL SMALL 3 CF Instructions For Use & Manual Daily Maintenance page 18

Bellfi res
Important: • If the pilot fl ame goes out for any reason, wait for 5 minutes
before attempting to re-light it.
• If the pilot light does not ignite after 3 ignition attempts;
close the gas tap and warn the fi tter.
• Once the pilot light is burning, the main burner must ignite
within 10 seconds automatically.
If this does not happen, immediately close the gas tap and
warn the fi tter.
• If the main burner ignites with a pop; immediately close the
gas tap and warn the fi tter.
Pilot gas adjustment screw
(Factory set) (Puncture the casing
with a small screwdriver)
Figure 4: Gas regulating block
• Possible error messages:
* 3 seconds: short beeps, audible when the motor-knob operates:
Receiver batteries need changing soon (having heard this signal, the
appliance can be ignited another ten times approximately).
* 5 seconds: unbroken beeps:
Error. For example, one of the cables may not be properly connected.
Important: If the pilot fl ame goes out, then wait for
at least 5 minutes before repeating the
above procedure.
18
8-wire Receiver Jack
Adjustment screw
Maximum burner pressure
(Factory set and sealed)
Microswitch
Instructions for use
English
Motor-knob