Rear Brake; Brake Disc Thickness Control; Check The Level Of The Rear Brake Fluid; Front Brake Lining Control - Beta evo 125SS 2022 Owner's Manual

4
1
A
EN
2 mm
2

FRONT BRAKE LINING CONTROL

In order to verify the wear condition of front
brake is enough to view the caliper from
the bottom, where is possible to glimpse
the brake lining tails which will have to
show a brake of 2 mm in thickness. If the
stratum is lesser let's start replacing them.
NOTE:
Perform the check according to the times
shown in the table on page 56.
To replace, contact authorised Betamotor
customer service.
BRAKE DISC THICKNESS
CONTROL
Periodically verify disc condition. In case
signs of damage , veins, or deformations are
present, proceed with replacement.
Verify disc thickness. The minimum thickness
is engraved on the disc.
Once the limit is in proximity or has been
reached, proceed with brake disc replace-
ment.
For replacement, contact an authorised
Betamotor after-sales service centre.

REAR BRAKE

CHECK THE LEVEL OF THE REAR
BRAKE FLUID
Check the level of the brake fluid through
sight A. The level of the fluid should never
fall below the mark in the sight.
42