Table of Contents
Advertisement
RESTORING THE LEVEL OF THE REAR BRAKE FLUID
To restore the level of the brake fluid, loosen the two screws 1, lift cap 2 and add
brake fluid until its level is 5 mm below the upper rim of the reservoir.
Use the liquid indicated on page 16 in the "Recommended lubricants and liquids" table.
WARNING:
The brake fluid is extremely corrosive. Take care not to spill it on the
paintwork.
Wear appropriate protective clothing and protection gloves.
Keep coolant out of reach of children.
WARNING:
Avoid any direct contact of the liquid with skin, eyes or clothing.
If this happens:
- with the eyes, rinse immediately with plenty of water and seek medical advice.
- with skin, immediately clean contaminated areas with soap and water. Change
clothing that is contaminated with liquid.
If liquid is swallowed, contact a doctor immediately.
BLEEDING THE REAR BRAKE
To bleed air from the rear brake circuit,
proceed as follows:
• Remove the rubber cap 1 from the valve
2.
• Open the sump cap.
• Insert one end of a transparent tube into
a container.
• Pump with the brake lever 2/3 times
and keep the lever pressed.
• Unscrew the valve and let the oil drain.
• If are still visible in the tube repeat above
operation until obtaining a continuous
outflow of oil within no air bubbles.
• Close the valve and release the lever.
NOTE:
During this procedure, continuously top up
the brake pump thank to replace the oil that
is out flowing.
1
2
43
4
EN
Advertisement
Chapters
Table of Contents
