Linkage Rear Suspension; Tyres - Beta evo 125SS 2022 Owner's Manual

4

LINKAGE REAR SUSPENSION

To guarantee an optimal operation and the 45Nm
longest lifetime of the progressive linkage
of the rear suspension, it is recommended
to check after every race/run the correct
tightening of the bolt.
Verify that the result of the suspension bolts
to specified torque.
To access the upper fixing, remove the
entire mudguard group (page 60).
30Nm
NOTE: It is recommended not to wash with
water jets at high pressure in the zone of
the linkage.
Perform the check according to the times
indicated in the table on page 56.
45Nm
To verify device, contact authorised Beta-
motor customer service.

TYRES

Only fit tyres approved by BETAMOTOR.
Unsuitable tyres can adversely affect the road holding of the vehicle.
• To protect your safety, immediately replace any damaged tyres.
• Slick tyres adversely affect the road holding of the vehicle, especially on wet roads
and in off-road riding.
• Insufficient pressure results in abnormal wear and overheating of the tyres.
• The front and rear tyres must have the same tread design.
• Always measure the inflating pressures when the tyres are cold.
• Keep the tyre pressures within the prescribed range.
EN
51