Registration Sensor Pcb - Brother MFC-J5335DW Service Manual

9.57 Registration Sensor PCB

(1) Release the wiring of the Registration sensor harness.
(2) Remove the four screws (TAPTITE CUP B M3x10) and remove the Frame base
ASSY from the Lower cover.
Assembling Note: When tightening the four screws (TAPTITE CUP B M3x10), tighten
TAPTITE CUP B M3x10
(3) Release the two Hooks A and two Bosses and remove the DX paper guide from
the Frame base ASSY.
(4) Release the wiring of the Registration sensor harness.
Assembling Note: When assembling the DX paper guide, be sure there is no
Boss
Boss
Hook B
Hook A
DX paper guide
them in the order shown in the figure.
Frame base ASSY
2
4
Fig. 3-158
looseness of the Harness.
Also, the two Hooks B at the right and left sides must be inserted
properly.
Fig. 3-159
3-125
1
TAPTITE CUP B M3x10
3
Paper feed arm frame ASSY
Lower cover
Hook A
Hook B
Boss
Frame base ASSY
Confidential