Inogen Rove 6 User Manual page 30

6. Unlock the columns by pushing the latch button away from the columns.
7. While holding the latch button open, slide column assembly out of the device by lifting and pulling on
the metal pull handle.
8. Remove the columns completely from the device by pulling outward on the metal pull handle.
9. Both columns are removed as one piece.
10. To install new columns, first remove the four (4) dust caps from the new columns.
11. Make sure there is no dust or debris where the dust caps were located.
12. Insert the new columns into the device immediately after removing the dust caps.
DO NOT leave the column ends exposed.
6
13. Push the columns until the latch makes an
audible click and returns to the closed position.
14. Push and fold metal pull handle flush to bottom
of columns.
IMPORTANT: You need to notify the device that
you have replaced the columns. This can be done
through the device itself or through the Inogen
Connect App.
15. Resetting the columns through the device
a. Connect the device to AC power but DO NOT
power on the device.
b. Press and hold the plus (+) and (-) minus button
for 5 seconds. The screen will display the
'sieve reset' informational icon.
c. Release the buttons once the 'sieve reset' icon
is displayed on screen.
d. Press the bell button once. The screen will
display the 'sieve reset success' informational icon.
e. Press and hold the power button to turn on the device.
16. Resetting the columns through Inogen Connect App
a. Open the Inogen Connect App on your mobile device or tablet.
b. Navigate to the Advanced screen.
c. Click on Additional Information.
d. Click the Column Reset button.
10.6 BATTERY CARE AND MAINTENANCE
Lithium-ion batteries require special care to ensure proper performance and long life. Use only compatible
batteries with your device.
©2023 Inogen, Inc. All rights reserved.
7
10
13
15c
Page 30 of 40
12
14
15d
16
96-13115-00-01 B