Table of Contents
Advertisement
MAINTENANCE
WARNING:
the machine.
Maintenance should be performed on a regular basis by qualified personnel.
Always follow proper safety precautions when working on or around any machinery.
Daily Maintenance
• Do a general cleaning by removing dust and chips from the machine.
• Empty debris collection drawer.
• Inspect and clean filters located on the machine base. Replace as needed. This will vary
based upon amount of use and type of work material.
• Check and tighten any loose mounting bolts.
• Inspect the power plug and cord.
• Keep area around machine clear of debris.
• Check for any unsafe conditions and fix immediately.
• Check that all nuts and bolts are properly tightened.
Note: When cleaning chips and debris from the machine, use a brush and a shop
vacuum. DO NOT blow off the machine with compressed air. The force of the compressed air
may force chips into critical mechanisms or may inflict injury to yourself or others.
Monthly Maintenance
• Inspect and clean the impeller and motor. Accumulated debris on the impeller blades will
reduce performance. Dust and debris accumulation on the motor will cause the motor to
overheat and fail.
Note: The motor and impeller cleaning may be altered based upon actual usage.
Whether increasing or decreasing the service frequency, the motor and impeller must be kept
clean to provide the best performance and service life.
Make sure the electrical disconnect is OFF before working on
25
25
Advertisement
Table of Contents
