Baileigh Industrial DDTM-8052-HD Operator's Manual page 20

7. Remove and clean the bottom debris tray under
the filter track.
8. Disconnect the down draft table from the power
supply.
9. Replace the Aluminum filters by lifting slightly on
the filter and pulling outward on the bottom and
then lowering the filter out of the frame.
10. Install a cleaned or new filter in reverse order.
These aluminum filters are washable and reusable,
however it will need to be replaced when worn,
damaged, or when they becomes so clogged that
washing is no longer effective.
11. For each filter track, install the first filter cartridge
into the housing and slide it fully into the cabinet.
12. Install the second filter cartridge until it is in place
next to the first cartridge. Do not allow the support
flange from each cartridge to overlap.
13. Repeat this for the third filter cartridge.
14. Secure in place using the retention handles.
15. Inspect the door seal, and replace if damaged.
16. Close and latch the maintenance door.
18
18