Cocraft HC85 Original Instructions Manual page 4

• Look after you tools. Make sure that they are clean and that the edges are sharp for
maximum effect and best results. Follow the manuals recommendations regarding lubrication
and replacement of accessories. Inspect the mains lead regularly. If it is damaged it should
be replaced by a qualified service technician. Inspect all leads and cables regularly to check
for any damage. Make sure that the machine's/tool's handles and controls are clean, dry and
free from oil and grease.
• Turn the power off. Pull out the plug and push in the emergency stop button before servicing
or changing any blades, drill bits, cutters or sanding discs.
• Remove all spanners and repair tools. Make a habit of checking to make sure that
the machine is free of all spanners and tools before turning the power on.
• Avoid accidental starting. Do not walk around with your finger on the trigger of a power tool
if it is plugged in. Make sure that the on/off switch is set to OFF before plugging in any power
tool.
• Use the correct extension leads. If you use extension leads outdoors, only use those
designed for outdoor use. Only use extension leads with thick enough diameter core wires
and roll out the whole lead.
• Use common sense and be careful. Think before carrying out any task, so that it is carried
out safely. Never operate machines/power tools when you are tired or under the influence
of medicine.
• Check the following before turning the tool on:
- That all guards and other parts are whole and in working order.
- That moving parts are free and correctly aligned.
- That no moving parts can get caught.
- That no defects are apparent.
Other factors that can influence work execution. A safety guard or any other part that is
damaged should be repaired by a tradesman or replaced. Damaged power leads and
switches must always be replaced by a tradesman. Never operate a tool if you cannot stop
or start the tool comfortably.
• Use only recommended accessories. The use of non-recommended accessories can cause
accidents and personal injury.
• Should only be repaired by a qualified technician. The tool conforms to current safety
requirements. Repairs to the tool should only be carried out by a tradesman using original
spares; otherwise the tool could cause accidents and personal injury.
Specific Safety Rules
• Always use safety glasses.
• Never use damaged grinding discs.
• Never use the chainsaw sharpener unless the guard is attached and undamaged.
• Only use grindings discs recommended by the manufacturer and that are rated at the same
or higher speed than the maximum rated speed of the machine.
• Read the manufacturer's instructions accompanying the grinding disc.
4