Place Front Panel Program Keys Into Enabled Mode; Place Tw Into Dc Mode - Elgar TrueWave TW 5550 Operation Manual

TW 3700 • TW 5550
3 .1 0 .5 P L ACE F R ONT P ANE L P R OGR AM K E Y S I NT O E NAB L E D MODE
Press the Up arrow key until the display reads:
ACCESS
Press the ENT key. Assuming the password is not set, the display will read:
CODE NOT SET
Press the Up arrow key. The display will read:
PROG FRT DIS
Press the Right arrow key. The display will read:
PROG FRT ENA
Press the ENT key. The display will read:
PROG FRT ENA
Press ABC/BACK repeatedly to back out of menus and return to readback display mode.
The Output and Prog keys are again operable.
3 .1 0 .6 P L ACE T W I NT O DC MODE
Press the Up arrow key until the display reads:
CONFIG
Press the ENT key.
Press the Up arrow key until the display reads:
COUPLING AC or
COUPLING AC-DC
Press the Right arrow key until the display reads:
COUPLING DC
Press the ENT key. The display will read:
COUP DC
Press ABC/BACK repeatedly to back out of menus and return to readback display mode.
Elgar TrueWave
Operation
3-15