Place Tw Into Standby Mode After Power Up; Place Front Panel Program Keys Into Disabled Mode - Elgar TrueWave TW 5550 Operation Manual

Operation
3 .1 0 .3 P L ACE T W I NT O S T ANDB Y MODE AF T E R P OWE R U P
Press the Up arrow key until the display reads:
STARTUP AUTO
Press the Right arrow key. The display will read:
STARTUP STBY
Press the ENT key. The display will read:
INIT STANDBY
Press ABC/BACK repeatedly to back out of menus and return to readback display mode.
3 .1 0 .4 P L ACE F R ONT P ANE L P R OGR AM K E Y S I NT O DI S AB L E D MODE
When the TW program keys are disabled, the Output key and Prog keys (VOLTAGE,
FREQUENCY/PHASE, and CURRENT/POWER) are all non-operable. In this mode the
TW will perform as last saved to system memory 0 and also can be controlled via the
SCPI interface.
Press the Up arrow key until the display reads:
ACCESS
Press the ENT key. Assuming the password is not set, the display will read:
CODE NOT SET
Press the Up arrow key. The display will read:
PROG FRT ENA
Press the Right arrow key. The display will read:
PROG FRT DIS
Press the ENT key. The display will read:
PROG FRT DIS
Press ABC/BACK repeatedly to back out of menus and return to readback display mode.
3-14
TW 3700 • TW 5550
Elgar TrueWave