Clearing The Password; Sample Menu Changes; Change Tw Gpib Address; Set Tw To Close Output Relay At Power Up - Elgar TrueWave TW 5550 Operation Manual

TW 3700 • TW 5550
3 .9 .2 CL E AR I NG T H E P AS S WOR D
Use the Up and Down arrow keys to get to the ACCESS menu command. Press the
ENT key to get to the CODE sub-menu. If the NOT SET mode is in effect at this time,
the passcode is already cleared. Assuming the NOT SET mode is not presently in
effect, press ENT once to get to CLEAR. If you wish to clear the passcode, press ENT
once. Press ENT once more at the ENTER TO CLEAR prompt. The password is now
cleared.
3 .1 0 S AMP L E ME NU CH ANGE S
3 .1 0 .1 CH ANGE T W GP I B ADDR E S S
Press the Up arrow key until the display reads:
SYST
Press the ENT key
Press the Up arrow key. The display will read:
PORT
Press the ENT key. If the present GPIB address is 25 the display will read:
GPIB ADDR 25
Either enter the new address using the 0-9 keys and press ENT, or press the Left arrow
or the Right arrow key to specify the new value for the GPIB address.
Press ABC/BACK repeatedly to back out of menus and return to readback display mode.
3 .1 0 .2 S E T T W T O CL OS E OU T P U T R E L AY AT P OWE R U P
Press the Up arrow key until the display reads:
STARTUP STBY
Press the Right arrow key. The display will read:
STARTUP AUTO
Press the ENT key. The display will read:
INIT RUN
Press ABC/BACK repeatedly to back out of menus and return to readback display mode.
Elgar TrueWave
Operation
3-13