PROAIM CINEMA P-W5P-WING Assembly Manual page 13

•
Red wire is properly connected with jib
section 1.
•
Follow the same procedure for the other
short red wire as shown in the image.
•
Insert one end of the cable into the hook of
the cable guide rod, then attach the other
end of the cable to the clamp of Section 8.
•
Follow the same process to attach the
2nd wire with the Jib, as shown in the
image.
Attaching the Blue
•
Attach the two Blue cables with the hook of
Section 1.
NOTE: Align the cable to the cable guide from
side and adjust the cable with help of wire
tensioner. Same approach apply at other side
of jib
•
Connect the end of the two blue cables into
the slot of section 8th with the help of the
knob.
•
Connect the other blue wire into the slot of
the same jib section 8 and adjust the length
of the wire with the help of a wire tensioner.
•
After attaching the blue wire, lock the wire
properly with a safety pin.
•
The blue wire is properly connected to the
jib section as shown in the image.
Stability Cables
13