Advertisement
BSAP 6120 QSG
Wall/Ceiling
Anchors
Mounting Bracket
Mounting Screws
Keyed Slots
Figure 2. Installing the BSAP 6120 on a Wall or Ceiling and Securing BSAP to Mounting Bracket
g
NOTE
The BSAP must be mounted on the bracket so that the locking tab on the bracket aligns with the threaded hole for locking screw on
the unit.
8. Slide the keyed slots on the back of the unit's chassis securely onto the bracket's protruding mounting tabs, and secure the BSAP 6120 to the
bracket by installing and tightening the locking screw (as shown in
9. Once the BSAP 6120 is securely installed, attach the grounding cable to a reliable earth ground point and proceed to the instructions provided in
"Supplying Power to the BSAP 6120"
Mounting the BSAP 6120 to a Pole
The BSAP 6120 also ships with pole mount hose straps to mount the AP to a vertical or horizontal pole. BSAPs should be positioned for maximum
throughput and range between other APs and wireless client devices. The BSAP should have the antennas and grounding wire attached before
installation (refer
to"Antennas"
and
To Mount the BSAP 6120 to a Vertical Pole:
1. Attach all antennas to the BSAP (refer to
2. Attach the grounding cable and screw to the BSAP (refer to
3. Thread the open end of the hose straps through the two tabs on the top and bottom of the mounting bracket so that the BSAP is aligned vertically
(as shown in
Figure
3).
4. Attach the chassis to the pole mounting bracket by sliding the keyed slots on the back of the chassis securely onto the bracket's protruding
mounting tabs
(Figure
3). Be sure to secure the BSAP 6120 to the bracket by tightening the locking screw illustrated in the image below.
Hose Strap Insertion
Figure 3. Insert Hose Straps for Vertical Mounting and Securing BSAP to Mounting Bracket
g
NOTE
The BSAP must be mounted on the bracket so that the locking tab on the bracket aligns with the threaded hole for locking screw on
the unit.
61700973F1-13B
Locking screw to prevent
the BSAP from being
accidentally dislodged.
on page 5
.
on page 2
"Grounding the BSAP"
on page 2
"Antennas"
"Grounding the BSAP"
Locking screw to prevent
the BSAP from being
accidentally dislodged.
Mounting
Bracket
Figure
2).
).
).
on page 2
).
Mounting
Bracket
Installing the BSAP 6120
3
Advertisement
