Advertisement
BSAP 6120 QSG
Supplying Power to the BSAP 6120
The BSAP 6120 does not have a power switch. It is powered when connected to a network device that supplies PoE+ based on the IEEE 802.3at
standard. To power the BSAP 6120, follow these instructions:
g
NOTE
This product is intended to have power supplied by an NRTL safety listed (certified) Power over Ethernet (PoE) adapter that complies with
IEEE 802.3at standards, provides 0.6 A minimum power, and functions within an ambient temperature of 140 degrees F (60 degrees C).
For further assistance, contact the manufacturer or brand owner of the PoE adapter for further information.
g
NOTE
Antennas must be installed on the BSAP 6120 prior to connecting power/PoE+ network devices. Refer to
information.
Connect the PoE Cable to the BSAP
1. Remove the cinch nut, strain-relief clip, and seals from the BSAP housing.
2. Insert the customer-provided RJ-45 CAT 5e or CAT 6 cable through the cinch nut and strain-relief clip, RJ-45 connector first.
3. Insert the connector into the RJ-45 receptacle on the bottom of the BSAP (the connector is recessed within the BSAP itself).
4. Separate the seals and place them around the cable near the inlet.
5. Gently push the strain-relief clip along the cable until it engages with the seals.
6. Slide the cinch nut over the strain-relief clip and seals until it engages the fitting threads. Tighten the cinch nut until it is fully seated, forming a
watertight seal. See
Figure
f
CAUTION!
For outdoor applications, the watertight fitting must be used when connecting PoE cables to the BSAP 6120. Failure to use the watertight
fitting when the unit is installed outdoors will void the user's warranty and could create a fire or shock hazard.
Connect the BSAP to a PoE Source
Figure 8
on page 6 illustrates how to provide power to the BSAP 6120 installed indoors and outdoors. Three examples are provided:
1. A PoE+ switch providing power in conjunction with NetVanta PoE+ Protector/Injector (PN: 1702595F15) installed indoors.
2. A non-PoE switch in conjunction with NetVanta PoE+ Protector/Injector (PN: 1702595F15) and an optional AC Power Adapter (PN: 1700501F1) to
provide power installed indoors.
3. A third-party outdoor rated 802.3at PoE+ injector (PowerDsine PD-9001GO) or equivalent with GR-1089-CORE or ITU-T K Series surge
protection.
f
CAUTION!
In all cases, connect the BSAP 6120 to Earth Ground. For outdoor applications, use only shielded or outdoor-rated Ethernet cable run
inside conduit to protect it from damage from extreme weather conditions and temperatures. Consult a certified electrician to ensure that all
grounding and cabling is installed in compliance with local electrical code. Any damage or malfunction resulting from exposure of this unit to
lightning or transient voltage events will void the user's warranty.
61700973F1-13B
7.
Antenna
Connectors
Seals
Strain-relief
Clip
Cinch Nut
Figure 7. Watertight PoE Fitting
Supplying Power to the BSAP 6120
RJ-45 Receptacle
and Connector
"Antennas"
on page 2
for more
5
Advertisement
