Installing The System Board Module - HP Cloudline CL2100 G3 806R User And Maintenance Manual

Installing the system board module

CAUTION:
static discharge.
Follow these steps to install the system board module:
Align the I/O ports on the system board with the slots on the chassis.
1.
Slide the system board into position. Make sure the I/O ports are seated correctly.
2.
Lower the system board onto the chassis. Make sure the screw holes on the system board and chassis
3.
are aligned.
Secure the system board module to the chassis with the screws.
4.
Connect the cables.
5.
Install the processors (on page 35).
6.
Install the heat sinks (on page 33).
7.
Install the DIMM modules (on page 38).
8.
Install the air baffle (on page 43).
9.
Install the OCP mezzanine card or the M.2 assembly (on page 52 or page 54).
10.
Install the riser card (on page 50).
11.
Install the access panel (on page 41).
12.
When removing any component, wear a properly grounded static strap to prevent
Installation 40