Installing The System Board Module - HP CL2100 G3 807S User And Maintenance Manual

Installing the system board module

CAUTION:
static discharge.
To install the system board module:
Align the I/O ports on the system board with the slots on the chassis.
1.
Slide the system board into position. Make sure the I/O ports are seated correctly.
2.
Lower the system board onto the chassis. Make sure the screw holes on the system board and chassis
3.
are aligned.
Secure the system board module to the chassis with the screws.
4.
When removing any component, wear a properly grounded static strap to prevent
Installation 36