9
Camera Functions
This chapter describes the camera functions.
9.1
ROI (Region of Interest)
This sets the ROI in order to output the selected area of image.
The frame rate increases when reducing the height of image. The frame rate does not change when reducing the
width of image.
GenICam Parameters
Width
Height
OffsetX
OffsetY
The parameters define as following chart.
(*) Width, Height, OffsetX, OffestY setting steps is the same in Binning and Decimation.
STC-MBS312U3V / STC-MCS312U3V / STC-MBS500U3V / STC-MCS500U3V
Product Specifications and Use's Guide
For more information please contact Aegis Electronic Group, Inc. *(888)687-6877 *aegis-g2@aegiselect.com *http://www.aegiselect.com
Integer Type
Horizontal (Pixel) size
Sets the width of image. "Width + OffsetX" should not exceed the maximum
width.
Integer Type
Vertical (Line) size
Sets the height of image. "Height + OffsetY" should not exceed the maximum
height.
Integer Type
Horizontal (Pixel) offset
Default: 0
Setting steps: 4 pixels
Integer Type
Vertical (Line) offset
Default: 0
Setting steps: 4 lines
ROI Region
OffsetX
Width
OffsetY
Height
No.16S024-02
39/64