Controls System Maintenance; Adjusting The Throttle - Toro 30839 Operator's Manual

Figure 56
1. Hydrostat drive belt
3. Replace the belt.
4. Reverse the procedure to tension the spring.
2. Spring end
Controls System
Maintenance

Adjusting the Throttle

1. Position the throttle lever rearward so it stops against
the control panel slot.
2. Loosen the throttle cable connector on the injection
pump lever arm (Figure 57).
1. Injection pump lever arm
3. Hold the injection pump lever arm against the low
idle stop and tighten the cable connector.
4. Loosen the screws securing the throttle control to
the control panel.
5. Push the throttle control lever all of the way forward.
6. Slide the stop plate until it contacts the throttle lever
and tighten the screws securing the throttle control
to the control panel.
7. If the throttle does not stay in position during
operation, torque the locknut, used to set the friction
device on the throttle lever, to 40–55 inch-lb (5–6
N-m). The maximum force required to operate the
throttle lever should be 20 lb (27 N-m).
44
Figure 57