Lubrication; Greasing The Bearings And Bushings - Toro 30839 Operator's Manual

Lubrication

Greasing the Bearings And
Bushings
Service Interval: Every 50 hours (Lubricate all bearings
and bushings daily when conditions
are dusty and dirty.)
Every 500 hours/Yearly (whichever
comes first)
The machine has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base
Grease. Bearings and bushings must be lubricated daily
when operating conditions are extremely dusty and
dirty. Dusty and dirty operating conditions could cause
dirt to get into the bearings and bushings, resulting in
accelerated wear. Lubricate grease fittings immediately
after every washing, regardless of interval specified.
The grease fitting locations and quantities are:
• Rear cutting unit pivot (Figure 31)
Figure 31
• Front cutting unit pivot (Figure 32)
Figure 32
• SideWinder cylinder ends (2) (Figure 33)
• Steering pivot (Figure 34)
• Rear lift arm pivot and lift cylinder (2) (Figure 35)
36
Figure 33
Figure 34
Figure 35