Specifications; Attachments/Accessories; Operation; Checking The Engine Oil Level - Toro 30839 Operator's Manual

Specifications

Note: Specifications and design are subject to change
without notice.
Overall Width - 68 inch width
of cut
Overall Width - 72 inch width
of cut
Length
Height to top of ROPS
Wheel Base
Track Width
Ground Clearance
Weight with cutting units
Models 30839 and 30843
Model 30826

Attachments/Accessories

A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
71.8 inches (182 cm)
75.8 inches (193 cm)
116 inches (295 cm)
70.8 inches (180 cm)
58.5 inches (149 cm)
57 inches (145 cm)
6 inches(15.3 cm)
2,124 lb (963 kg)
2,099 lb (952 kg)
22

Operation

Note: Determine the left and right sides of the
machine from the normal operating position.

Checking the Engine Oil Level

Service Interval: Before each use or daily
The engine is shipped with oil in the crankcase;
however, the oil level must be checked before and after
the engine is first started.
Crankcase capacity is approximately 4 qt (2.8 l) with
the filter.
Use high-quality engine oil that meets the following
specifications:
• API Classification Level Required: CH-4, CI-4 or
higher.
• Preferred oil: SAE 15W-40 (above 0ºF (-17ºC))
• Alternate oil: SAE 10W-30 or 5W-30 (all
temperatures)
Note: Toro Premium Engine oil is available from your
distributor in either 15W-40 or 10W-30 viscosity. See
the parts catalog for part numbers.
Note: The best time to check the engine oil is when
the engine is cool before it has been started for the
day. If it has already been run, allow the oil to drain
back down to the sump for at least 10 minutes before
checking. If the oil level is at or below the "add" mark
on the dipstick, add oil to bring the oil level to the "full"
mark. DO NOT OVERFILL. If the oil level is between
the "full" and "add" marks, no oil addition is required.
1. Position the machine on a level surface.
2. Remove the dipstick (Figure 20) and wipe it with
a clean rag.
Figure 20
1. Dipstick